CADSoftTools

I have
- Cadview 14
- Total Commander 32 bit
- 32 GB RAM
- a DXF with 260 MB

To view it with Ctrl+Q, it runs the progress bar from 0 - 100 %, and then it shows a dialogue: "Out of memory"

The PC uses obly 8 of 32 GB RAM.

Why there is not enough memory?

Hello Peter,

It appears that you have reached the 32-bit architecture memory limit (approximately 3.3 GB per process). Please check how much memory is used by TOTALCMD.EXE process, in case it's ~ 3.3 GB when loading the 260 MB DXF, you should use Total Commander 64 bit (TOTALCMD64.EXE).

Mikhail

Hi

it uses "only" 1.7 GB. See picture - taken 1 sec. before error-message.

Solved - with TC64 it goes up to 2.2 GB and shows it well.