Suggestion: Disable Layouttoolbox if only one ...

[Peter]

I think it would be an improvement if the Layouttollbox becomes more "intelligent":

If
- in a drawing is only modelspace (i.e. DXF, older DWG) or
- in a plot is only one page the layouttollbox should be disabled.

This is usefull because now if have always to click on the box to see if there are more entries. If it is disabled I can see immediatly that there are no other layouts or pages.

Peter

[support]

Hello Peter,

Thank you for the interesting thought. We will consider it.

Sergey.

Please post questions to the forum or write to support@cadsofttools.com

[Peter]

Or - instead of disabling the toolbar - you can add additional info in the bar:

- "2 Page(s) found in Plotfile"
- "1 Modell and 3 Layout(s) found in DWG"

Peter

[support]

OK. Thanks again, Peter. We will consider this question.

Sergey.


Please post questions to the forum or write to support@cadsofttools.com

[Peter]

Seem to be added, but not listed in "History.txt / Changes.txt".

True?

Peter

[support]

True!